|
United States of America
Department of Transportation ----Federal
Aviation Administration
Supplemental Type Certificate
| This certificate, issued to |
NASCO Aircraft Brake Inc.
13300 Estrella Avenue
Gardena, California 90248 |
certifies that the change in the
type design for the following product with the limitations and conditions therefor
as specified hereon meets the airworthiness requirements of Part *CAR
4b of the Civil Air Regulations.
Original Product - Type Certificate Number:
Make:
Model: |
A3WE
Boeing
727-100 and -200 Series |
Description of Type Design Change:
Installation of NASCO rotor part number
717001-1,-2, -3, and -4 in Bendix Brake Assemblies part number 2601182-5 or -6
in accordance with NASCO Configuration Control Document NCC001, revision "B",
dated September 28, 1988, or later FAA approved revision.
Limitations and Conditions:
The system should not be incorporated in
any aircraft unless it is determined that the interrelationship between this installation
and any previously approved configuration will not introduce any adverse effect
upon the airworthiness of the aircraft. The approval of this change in type design
applies only to 727-100 and -200 airplanes equipped with Bendix Brake Assemblies
2601182-5 or -6.
This certification and the supporting
data which is the basis for approval shall remain in effect until surrendered,
suspended, revoked, or a termination date is otherwise established by the Administrator
of the Federal Aviation Administration.
Date of application: September 18, 1984
Date of issuance: October 5, 1988 |
Date issued:
Date amended: April 3, 1992
|
|
